![]() 4) Enter enable to leave password recovery enabled, or enter disable to turn it off. 2) Perform a hard reset by removing power, waiting 10 seconds, and then re-applying power.ģ) Once the switch has rebooted, enter a new password for the 'admin' user account. The unit will remain in password recovery mode for 30 seconds max. Connect the console cable, open a connection to the serial port via a utility such as PuTTY, and do the following: 1) Enter the user name 'recover' and password 'recover' to place your unit in password recovery mode. This will be denoted with the prompt: “CFE>” At the prompt execute the following commands: CFE>passwrd CFE>reset -sysreset At this point the password has been reset. Type a Ctrl/C until you enter the failsafe mode. Use the included cable, or be sure that the pin-out complies with a standard null-modem cable Once the cable is connected, reboot the switch. Be sure the terminal emulator program is set to VT-100 management using compatible, 38400 baud rate, no parity, 8 data bits and Console connection one stop bit. 80 Answers SOURCE: The resetting of the password requires the installation of a console cable to the console port.For the 3Com Baseline Switch 2916-SFP Plus/2924-SFP. 3Com® Baseline Switch 2916-SFP Plus and Baseline Switch 2924-SFP. Is there a way to obtain last firmware for the 3Com HP Baseline Switch 2824-SFP Plus (24 Port)? The part number is 3C16487 JE738A. ![]() View full 3Com Baseline Switch 2824-SFP Plus specs on CNET.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |